Smartek-systems SVS-1 User Guide-Part B Manual do Utilizador descarregar pdf (Página 11)

Setting Output - Example Scenario Summary

From the Main Setup display, proceed to the Set Output display by clicking the Set Output button. This display is used to specify the

detector interface type , combine phases into vehicle presence relays, and then route them to output detector channels. After setting up

the output relay signals, return to the Main Setup display by clicking the Main button.

The following list provides a summary of several SVS-1 Output setup examples which are shown in the slides that follow.

1) Type-170 Detector/Controller Interface with 4 Relays per SVS-1 card and 3 Phases (Line Zone Groups)

Phase 1L, Detection Delay=0 sec, Detection Extension=0, Route to Card Edge F

Phase 6T, Detection Delay=0 sec, Detection Extension=0, Route to Card Edge W

Phase 6R, Detection Delay=2 sec, Detection Extension=0, Route to Card Edge W

2) Type-170 Detector/Controller Interface with 2 Relays per SVS-1 card and 3 Phases (Line Zone Groups)

Phase 1L, Detection Delay=0 sec, Detection Extension=0, Route to Card Edge F

Phase 6T, Detection Delay=0 sec, Detection Extension=0, Route to Card Edge W

Phase 6R, Detection Delay=2 sec, Detection Extension=0, Route to Card Edge W

3) BIU #1 Card file Detector/Controller Interface with 4 Relays per SVS-1 card, Slot 2 used, and 3 Phases (Line Zone Groups)

Phase 3L, Detection Delay=0 sec, Detection Extension=0, Route to Detector Channel D1

Phase 8T, Detection Delay=0 sec, Detection Extension=0, Route to Detector Channel D2

Phase 8R, Detection Delay=2 sec, Detection Extension=2, Route to Detector Channel D2

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 44 45

Sem comentários

Smartek-systems SVS-1 User Guide-Part B Manual do Utilizador Página 11